Anetsberger Brothers FFM-80 User Manual download pdf (Page 6)

OIL DISPOSALOIL DISPOSAL

OIL DISPOSAL

If the cooking oil or shortening from a fryer is to be disposed, follow steps 1 and 2 from Filtering Instruc-

tions in previous section. Turn on the pump using the switch on the filter and direct the oil into an appro-

priate device such as an oil shuttle to move the used oil to its disposal tank.

IMPORTANT NOTE:

The pump on this filter unit is equipped with a safety that will turn off the motor if it overheats or an

electrical fault occurs. If this occurs, let the pump motor cool for 15 minutes, then press the manual

reset button on the bottom of the motor and restart the motor.

DANGER

Never run water through the filter system. This will cause rust and corrosion in the

motor and pump and will void the Warrranty.

WARNING

Always wear protective heat-resistant gloves when performing the oil disposal operation.

6. On gas-operated thermostat models (such as Anets 14G, 14GS, MXEG, 18EG, 20EG) the thermostat

knob can now be turned back to the desired temperature. CAUTION: On these models the thermostat

must be set to “OFF” or the Gas Valve to “PILOT” before filtering or the burners MAY come back on if

the doors are closed during filtering.

7. On electric-operated thermostat models (such as Anets MX-14E, MX-14EX, MX-14AA, 18E, 18AA,

20E, 14EL-14 and 14EL-17) the power switch on the control panel must be reset for the fryer to

operate again.

1 2 3 4 5 6 7 8 9

No comments

Anetsberger Brothers FFM-80 User Manual Page 6